Characterization of coffee residues pellets and their performance in a residential combustor

Spent coffee grounds (SCG) and coffee husks (CH) were evaluated as biofuels, after densification, for energy production. CH represent a specific problem for the coffee industry due to a low calorific value, high ash content, and a very low bulk density. Hence, the energetic potential of SCG (95 wt%)/CH (5 wt%) blend and pure SCG (100%) were examined. The blend of SCG and CH was limited to 5 wt% of CH because of the low bulk density of CH. Therefore, physicochemical and energetic characterizations of the produced pellets were performed. Thermogravimetric analyses were performed under nitrogen and air atmospheres to evaluate the CH behavior in the blend. Characterization study shows that both produced pellets could reach the French Agropellets standard (AQI). Thermal degradation showed that the mean reactivity of the SCG/HC pellets was higher than pure SCG. Then, combustion experiments were performed in a domestic combustor, after modification of the boiler power in order to improve its energetic performances. The presence of CH led to a rise of CO, NOx, VOC’s, and particle emissions. Nevertheless, the performances of the biofuels are almost in agreement the NF EN 12809 standard.     

An experimental apparatus for testing biodiesels based on a CFR engine—setup and validation with different methyl ester blends

A cooperative fuel research (CFR) engine was modified and instrumented in order to control operating conditions and to measure engine parameters and in-cylinder pressure diagrams. Aiming at the comparison of different alternative fuels, an experimental procedure was defined, including cetane number (CN) evaluation and the definition of engine operating quantities in different working points, for fixed levels of compression ratio (CR) and injection advance. An investigation was made considering several blends of methyl-esters of rapeseed oil (RME) and of a mix of vegetable oils (VOME) with conventional diesel oil. The defined experimental procedure was applied to assess CN, engine brake thermal efficiency (bte) and exhaust emissions. Results show that the biodiesel content has a positive influence on soot emissions, with strong reduction, while thermal efficiency and NO_X emissions are negatively affected, which can be justified taking into account fuel properties and changes in combustion process. As observed outcomes are generally in line with those presented in literature, the facility proved to be a suitable tool for basic investigations on alternative fuels to be used in specific applications.     

热处理时间对餐厨垃圾高温干式厌氧发酵的影响

餐厨垃圾中有机物大部分以大分子的形式存在,对其进行热处理,破坏大分子有机物的存在形式,将会影响其干式厌氧发酵的过程。实验对餐厨垃圾进行了热处理(100℃),处理后将其在含固率(TS)20%、接种率25%的条件下进行高温55℃厌氧发酵。实验结果表明,热处理后,餐厨垃圾的理化性质发生显著变化,累计产气量、TS和VS的去除率均增大。当热处理时间为15 min时,餐厨垃圾的SCOD值最高,为59.49 g/L,比未处理时提高了3.3倍。同样该条件下,累计产气量也最高,为2 782.8 m L,与未处理相比累积产气量提高58.30%,第二产气高峰比未处理提前3天。各发酵瓶发酵前后TS、VS去除率的变化趋势与累计产气量的变化基本一致,累计产气量越大,TS、VS的去除率越大。     

单光子/光电子在线质谱实时分析聚氯乙烯热分解/燃烧产物

实验室研制了低能光电子磁场增强电离(MEPEI)和单光子电离(SPI)复合电离源,该电离源具有电离化合物范围宽、碎片离子少、质谱图简单等优点,结合飞行时间质谱(TOF-MS)实现了聚氯乙烯(PVC)热分解/燃烧产物的在线分析.针对不同的目标化合物,MEPEI/SPI复合电离源通过调节电离区电场强度,可以快速在SPI和SPI-MEPEI之间切换.PVC热分解/燃烧产物中电离能大于光子能量(10.60 eV)的HCl和CO2(12.74 eV、13.77 eV)利用MEPEI模式电离;而烯烃、二氯乙烯、苯系物、氯苯、苯乙烯、茚满及萘系物等可通过SPI-MEPEI复合模式电离.通过实时监测PVC主要燃烧产物的信号强度随温度的变化趋势可推断出,PVC燃烧产物主要是通过两种机制生成:①250～370℃时,PVC发生脱氯及分子内环化反应,产生大量的HCl、苯和萘;②380～510℃时,PVC发生分子间交联反应,生成烷基芳烃,如甲苯和二甲苯/乙苯等.实验结果表明,SPI/SPI-MEPEI复合离子源TOF-MS分析速度快,应用范围广,在在线分析中具有广泛的应用前景.     

2002～2012年乌江渡水库水质变化趋势分析

为了解乌江渡水库水质变化趋势,对2002～2010年乌江渡水库水质监测结果进行了分析。采用综合营养状态指数法、污染分担率法、秩相关系数法,对水库富营养化等状况进行评价。结果表明,近年来,乌江渡水库总磷和总氮污染分担率之和达78%,是水库主要污染物,水库水质从大岭岗、偏岩河口到大坝,富营养程度逐渐加重;水库中总氮、氨氮、粪大肠菌群和五日生化需氧量也均呈显著上升趋势。建议加大乌江渡水库水质中总磷和总氮等的监测力度,加强防护与控制管理。     

Eutrophication development and its key regulating factors in a water-supply reservoir in North China

Yanghe Reservoir is an important source of drinking water for Qinhuangdao City,North China;however,in recent decades this water source has been eutrophic with recurrent summer cyanobacterial blooms.The trophic grade of the system in summer was mesotrophiceutrophic in 1990 and became hypertrophic in 2011.The nutrient availability is extremely high during the entire year,and the water temperature should be the primary driver of the summer blooms.In May-October of 2010 and 2011,abrupt variations were observed in the Secchi depth(SD) and chlorophyll a(Chl-a),and both the correlated analysis of Chl-a-SD and trophic status indices(TSI) deviation(TSI Chl-a-TSI SD) showed that algal cell density dominated light attenuation.During the algal bloom outbreak,the microcystin concentration was found to vary between 0.35-2.12 μg/L in 2010 and 0.11-1.86 μg/L in 2011.The maximum microcystin content was more than two times the safety limit required for drinking water.Inflow discharges were most concentrated in the summer,with periods of lower residence time and the largest water level fluctuation over the entire year.When a high availability of nutrients promoted a high Chl-a concentration in the whole system,it appeared that the instability caused by the decrease in residence time could not produce effective changes in the cyanobacterial abundance.The results indicated that nutrient enrichment in the aquatic systems of Yanghe Reservoir is the most serious problem and that the status would not been modified effectively by increasing hydrological fluctuations(e.g.,decreasing the residence time).Therefore,decreasing the nutrient concentrations is the only route to improve the water quality of this reservoir.     

Preparation of MgO/B2O3 coatings by plasma spraying on SUS304 surface and effects of heat-resistant

This study mainly deals with the preparation of MgO/B₂O₃ coatings by plasma spraying on the SUS304 surface and the effects of heatresistant. The power materials of low thermal conductivity were selected to control the heat divergent performance of high temperature parts. The reticular micro-structure between the cover thermal layer and the substrate was prepared by using the plasma spraying method. The powder mixture of MgO and B₂O₃ were selected as spraying materials and the SUS304 was used as the substrate material. The MgO/B₂O₃ coating was prepared on the surface of the SUS304 to provide better cover thermal performance. The properties of the microstructures and the morphologies were studied by Optical Microscope, Scanning Electron Microscope, Electron Probe Microanalyzer, and X-ray Diffraction. The results showed that the cover thermal performance has been improved.     

厦门石兜-坂头水库水体营养状态综合评价及变化趋势分析

以水质监测资料为基础,采用综合营养状态指数法（TLI法）和线性插值评分法（SCO法）2种模式,相互印证并综合评价2008．5—2011．6厦门石兜-坂头水库库区水体营养状态。应用Daniel的趋势检验,对评价时段内水库水体营养状态和水质参数（总氮、总磷以及氮磷浓度比）变化趋势进行分析。结果表明：2008年5月-2011年6月期间,石兜-坂头水库水体营养状态为中营养至轻-中度富营养;在此评价期内,总磷、总氮、氮磷比值趋势变化不显著;水体营养状态变化趋势也没有显著意义,始终在中营养至（轻-中度）富营养状态区间波动。水库周边环境及水质的监管措施能否及时到位是影响库区水体营养状态变化的关键。     

热脱附-气相色谱-质谱法测定环境空气中5种挥发性卤代烃

建立热脱附-气相色谱-质谱联用测定环境空气中三氯甲烷、四氯化碳、三氯乙烯、四氯乙烯、溴仿等5种挥发性卤代烃的分析方法。该方法在一定浓度范围内工作曲线线性良好,相关系数均在0．9990～0．9998之间,加标回收率在94．0％～106．6％之间,RSD为2．18％-7．62％,检出限为0．22μg／m3～0．30μg／m3。该方法具有操作简单、分析快速、准确度高、灵敏高的特点,用热脱附-气相色谱-质谱联用测定环境空气中5种挥发性卤代烃,结果令人满意。     

关于医疗垃圾飞灰中二噁英在惰性气氛下的低温热脱附研究

以医疗垃圾焚烧炉布袋除尘器前管道内飞灰(BG)及布袋除尘器后飞灰(AG)为对象,研究不同温度及时间段下其在管式炉中的热脱附特性.结果表明,在低温氮气气氛下,热脱附作用较为明显,2种飞灰中的二噁英都有了不同程度的脱除,其中布袋前飞灰中二噁英的脱除率为82.9%～99.9%之间,毒性当量脱除率为77.3%～99.8%,布袋后飞灰中二噁英的脱除率为66.8%～99.8%之间,毒性当量脱除率为43.5%～99.6%.检测收集到的实验尾气,发现了二噁英的存在,且在300～350℃这个温度段生成量最多,且生成的有毒二噁英同系物中以OCDD为主.通过比较发现,当温度为400℃,加热时间为45 min时2种飞灰中的二噁英脱除效率最高.鉴于惰性气氛下的热脱附对处理飞灰中的二噁英具有较好的作用,可将其大规模应用于实际工程中.